Materials:
- Fimo in black, sea green and white.
-fine grit on
Instructions:
1. are used three shades of green. To make the darker parts of sea-green mix 2 to 1 in black. For intermediate use only green. For the clearest, mixing equal parts green and white.
2. Two bars are made bull's-eye with the darkest color in the center, varying the thickness of the layers and the arrangement of tones green, putting many layers, from very fine to medium. The two bars have approximately the same size.
3. Assemble the two bars next to each other. Do much more than two gadas and different and put them in the spaces between the two thick bars as indicated.
4. Dedistintos stacking thin layers of green tones, forming a sheet of sufficient size to wrap the set of bars formed in the previous step. Wrap and connect the edges of the sheet.
5. With a round tool (like a knitting needle), press the sides of the foil wrap to make slits in the modeling these bars. There should be no gaps or air bubbles between the inner bar and the blade. If you want you can add a new layer using a slightly different color.
- Fimo in black, sea green and white.
-fine grit on
Instructions:
1. are used three shades of green. To make the darker parts of sea-green mix 2 to 1 in black. For intermediate use only green. For the clearest, mixing equal parts green and white.
2. Two bars are made bull's-eye with the darkest color in the center, varying the thickness of the layers and the arrangement of tones green, putting many layers, from very fine to medium. The two bars have approximately the same size.
3. Assemble the two bars next to each other. Do much more than two gadas and different and put them in the spaces between the two thick bars as indicated.
4. Dedistintos stacking thin layers of green tones, forming a sheet of sufficient size to wrap the set of bars formed in the previous step. Wrap and connect the edges of the sheet.
5. With a round tool (like a knitting needle), press the sides of the foil wrap to make slits in the modeling these bars. There should be no gaps or air bubbles between the inner bar and the blade. If you want you can add a new layer using a slightly different color.
6. Cut slices to malachite dummy bar for the project and bake according to manufacturer's instructions. Finally, when cold malachite carefully sanding and polishing to polish.
0 comments:
Post a Comment